FAQ

What Dowel Pins Are Need For Use In 6045 Kits W/ 2-630T-ST Flywheel?
If a customer inquires about what dowel pin to press into their 2-630T-ST/STU flywheel and they have a 6045-xxxx kit, indicate to them that they're to ...
Fri, 24 May, 2019 at 3:35 PM
I cannot get my vehicle out or into gear (no release) or I am having problems in high rpms my clutch will not disengage (high rpm lockout).
Check clutch linkage adjustment. Clutch linkage should be adjusted when new clutch installed into vehicle, also linkage should be re-adjusted after first ...
Fri, 24 May, 2019 at 3:40 PM
Why did my spring come out of the disc?
Make sure all the dowel pins are in the correct position on the transmission to insure correct engine to transmission alignment. During install the trans...
Fri, 24 May, 2019 at 3:41 PM
Why is my clutch slipping?
Slipping occurs when the driven disc fails to rotate at the same speed as the driving members when the clutch is engaged. This condition occurs when the p...
Fri, 24 May, 2019 at 3:42 PM
My clutch pedal is stuck to the floor.
The hydraulics of the car could be faulty or have air in the lines (bleed clutch). Check clutch master cylinder, slave cylinder for any signs of leaking o...
Fri, 24 May, 2019 at 3:43 PM
What are the causes of poor shifting quality or notchy shifting?
Improper clutch release caused by faulty linkage and/or improper release linkage adjustment Improperly install shifter Bent shift fork/ damaged pivot bal...
Fri, 24 May, 2019 at 3:44 PM
What could be the causes for clutch judder (chatter or shudder)?
Improper break-in procedure Flywheel was not properly resurfaced before new clutch installed Flywheel is not parallel, or the friction surface is out of...
Fri, 24 May, 2019 at 3:44 PM
What is the break in procedure of each stage clutch?
Organic (2100,0150, MA,MB) Easy street driving, no long slips, burnouts, or hard launches for 500 -700 city miles Ceramic (1620, 0620, 1420, 0420, 2600...
Fri, 24 May, 2019 at 3:51 PM